If you still have your owner's manual, go to page 21 for complete directions. If you don't, it reads like this:
1. Set the interior light switch to the
“DOOR” position. (See “Interior light”
on page 93 in Section 1?5.)
2. Shift the selector lever into the “P”
position and close all doors.
3. Turn the ignition switch to the “ON”
position.
4. Within 5 seconds after the ignition
switch is turned to the “ON” position,
push and hold the power door lock
switch on the front side for about 5
seconds.
5. The interior light will flash to indicate
that the mode has been changed.
The flashing of the interior light indicates
the mode which has been selected.
Flashing once, the function has
changed to mode 1.
Flashing twice, the function has
changed to mode 2.
Flashing three times, the function has
changed to mode 3.
Flashing four times, the function has
changed to mode 4.
If the battery is disconnected or run down,
the mode may change. Set the desired
mode by following the above procedure.
Mode 1—Automatic locking linked
with the shift position
All doors are automatically locked when
the selector lever is moved out of the
“P” position with the ignition switch in
the “ON” position and all the doors are
closed.
Mode 2—Functions cancelled
Automatic door locking and unlocking
functions do not activate in this mode.
Mode 3—Automatic locking and unlocking
linked with the shift position
Locking function—All doors are automatically
locked when the selector lever
is moved out of the “P” position
with the ignition switch in the “ON”
position and all doors are closed.
Unlocking function—All doors are automatically
unlocked when the selector
lever is moved to the “P” position with
the ignition switch in the “ON” position.
Mode 4—Automatic locking and unlocking
linked with the shift position
and ignition switch
Locking function—All doors are automatically
locked when the selector lever
is moved out of the “P” position
with the ignition switch in the “ON”
position and all doors are closed.
Unlocking function—All doors are automatically
unlocked when the ignition
switch is turned from the “ON” position
to the “ACC” or “LOCK” position.
Hope this helps. God Bless!Changing Power Lock Option/Feature in Toyota Corolla?
Try your owner's manual. I think this can be programmed differently. I think it involves operating the remote in some special sequence. If the om doesn't tell you maybe if you take it to a Toyota dealer for an oil change they will re-program it for free. it can't take more than 30 seconds if you know the secret code.
